When considering options for laser diode driver design the determining factors include size, weight, cost, efficiency, and reliability over specified environmental operating conditions. Unfortunately, these factors are often in conflict with one another. The least expensive approach often will not be…
sales@analogmodules.com | 
1-407-339-4355
Blog Archives
Switch Mode Laser Diode Driver Design
Switch Mode Laser Diode Driver Approximately 20 years ago, as industry was starting to replace linear designs with switch mode power supplies to achieve smaller size and higher efficiency, Hughes Aircraft Company in 1994 disclosed a resonant buck converter to provide…
Posted in Laser Electronics, Technical Note
Linear Laser Diode Driver Design
Linear Laser Diode Driver Solution The AMI Model 778 Laser Diode Driver was an early example of the simple linear design approach. This driver and the current version, AMI Model 779A, has been available for 25 years. In such a design,…
Posted in Laser Electronics, Technical Note
Design of Laser Diode Drivers
Design and Optimization of High Current Laser Diode Drivers INTRODUCTION These posts will explain the development and technical challenges encountered in the design of laser diode drivers, especially high current devices used in military applications. The pros and cons of simple…
Posted in Uncategorized
OSCILLATION IN AMPLIFIERS
OSCILLATION IN AMPLIFIERS Most amplifiers work without problems, but in some cases oscillations may occur with high frequencies/high gains and/or poor layout. The first step is to measure the frequency and amplitude of the oscillation. Use the internal triggering of…
Posted in Sensors and Amplifiers, Technical Note
HOW TO MEASURE NOISE
Specifically How to Measure Noise when using AMI’s transimpedance and voltage amplifiers VERIFICATION When determining how to measure noise one question that is frequently asked is how to verify the noise performance of voltage and current amplifiers. This note suggests…
Posted in Sensors and Amplifiers, Technical Note
Design of Capacitor Charging Power Supplies
Introduction Design of Capacitor Charging Power Supplies: In order to power laser flashlamps, pulse forming networks, and other energy storage capacitor applications, the capacitor is charged up in voltage, then regulated. This creates an unusual and different situation from conventional…
Posted in Laser Electronics, Technical Note
Transimpedance Amplifier Selection
Transimpedance Amplifier Selection Guide AMI designs and manufactures a range of Transimpedance Amplifiers for OEM, medical and research applications primarily for use with photodetectors. AMI’s amplifiers combine low noise, high gain, large dynamic range, and small package size. The key…
Posted in Sensors and Amplifiers, Technical Note Tagged with: How To, Sensors and Amplifiers, Transimpedance
Final day of SPIE.DCS, AMI at SPIE Defense and Commercial Sensing Conference
Today is the final day of SPIE Defense & Commercial Sensing Conference. Tim Ayres and Gary Sweezey will be in AMI’s booth on the show floor from 10AM to 2PM EDT for the final day of the SPIE Defense & Commercial…
Posted in Uncategorized
AMI at SPIE Defense & Commercial Sensing Conference, SPIE.DCS Day Two
SPIE.DCS Day Two After a productive first day AMI at is looking forward to the second day of the SPIE Defense and Commercial Sensing conference in Baltimore, MD. Please stop by AMI’s booth, 422. The show floor is open from 10AM…
Model 755A-04.1
Hybrid eyesafe laser rangefinder receiver is designed for laser rangefinding & surveying equipment. Compact construction is ideal for miniature applications. Fast recovery from T0 overload allows ranging to close objects without compromising long range performance. The incorporation of an InGaAs APD gives very high sensitivity with time programmed gain to minimize false targets. Operation at both 1.06 µm and 1.54 µm is possible over a wide range of pulse widths.
